Motorola Symbol MiniScan MS1207FZY, Integration Manual

Page: 25 / 368

Installation 2 - 3
Mounting the Scanner on the Optional Stand
To mount the scanner on the optional stand:
1.
Place the bottom of the scanner on the stand’s scanner mount, aligning the scanner’s center threaded insert
(beneath the scan window) with the center mounting hole on the front of the stand. The two rear threaded
inserts on the bottom of the scanner align with the proper mounting holes on the stand.
2.
Secure the scanner to the stand using the three screws provided with the stand.
Assembling the Stand
Figure 2-3
Assembling the Stand
Mounting the Stand (optional)
You can attach the base of the scanner’s stand to a flat surface using two screws or double-sided tape (not
provided).
Screw Mount
1.
Position the assembled base on a flat surface.
2.
Screw one #10 wood screw into each screw-mount hole until the base of the stand is secure.
Stand base
Wingnut
1.
Unscrew the wingnut from the bottom
of the one-piece scanner mount.
2.
Fit the bottom of the neck piece into
the opening on the top of the stand
base.
3.
Tighten the wingnut underneath the
base to secure the cup and neck piece
(see the note below).
4.
Bend the neck to the desired position
for scanning.
Scanner mount
Flat areas
Mounting holes
NOTE Before tightening the wingnut under the base, ensure that the flat areas on the flexible neck fit securely in
the grooves in the base.