B
3 Installing the Digital Voice Modem
17
POWER
3
2
1
4
5
POWER
3
2
1
4
5
Testing the Connections
To verify that all the components were properly installed, perform the following connectivity test:
1.
Power on your computer.
2.
Check the LEDs on the SBV6120 front panel.
The TEL 1 and TEL 2 LEDs should be
on
, if the SBV6120 was provisioned for voice
service. Otherwise, TEL 1 and TEL 2 will be
off
.
The remaining LEDs should be
on
or
flashing
.
Note
: Refer to
for LED status information.
3.
Open a web browser.
4.
Go to any website to check for an Internet connection.
5.
Check the telephone for a dial tone. If there is no dial tone, then your telephone line is not
set up for voice service.
Note
: Contact your service provider to provision the telephony line(s).
If the connectivity test failed, see
for a possible solution.
You may now wall mount your SBV6120 digital voice modem. See
for more information.
