4
Press the
Menu Select
button directly below
Ok
.
The display shows the radio Contact IDs.
5
Perform one of the following actions:
•
or to the required ID.
• Press the
Menu Select
button directly below
LNum
to go to the last number dialed.
• Use the
keypad
to enter the required ID.
• Press the
Menu Select
button directly below
Send
to initiate command.
If the receiving radio received the command, your
radio display shows
Ack received
.
If the receiving radio does not have encryption key to
decrypt the received encrypted command, your radio
display shows
Decrypt failed
.
If the receiving radio is powered off or already killed,
your radio display shows
No Acknowledgment
.
Once the receiving radio received the command, its screen
turns blank, the killed radio is inoperable.
Using Direct Kill to Kill Your Own Radio
Direct Kill allows you to make your own radio inoperable.
Press and hold the
Top Side
button then press the
Orange
button until the display turns blank and
becomes inoperable.
Radio Inhibit
This feature allows the system administrator to put a radio
into a non-functional state when the radio is missing or in
an unknown hand. The radio stays in this state regardless
of power changes, for example, battery removal.
NOTICE:
If the radio has Inter-system roaming capability, the
system administrator is able to put the radio into a
non-functional state when missing radio roamed to
another system.
The radio can only be uninhibited by receiving an
uninhibit command from the system administrator or
reprogram the radio through labtool or depot CPS
only.
English
153