Motorola SE4710, Integration Manual

Page: 70 / 82

6 - 8 SE4710 Integration Guide
Snapshot Mode
Level/Presentation/Auto-Aim Trigger Mode Procedure
The system is initialized as follows:
•
The host sends the Aim Off command.
•
The host sends the Illumination Off command.
•
The host sends the Acquisition Stop command.
•
The host sends the Acquisition Mode command with Document Capture.
•
The SE4710 optimizes the image output for image capture.
•
The SE4710 (typically) enters low power mode.
Upon a trigger pull:
•
The host sends the Illumination On command.
•
The SE4710, if in low power mode, exits low power mode (either Reduced or Sleep).
•
The host sends the Aim On command.
•
The host sends the Acquisition Start command.
•
The SE4710 captures an image.
Upon completion of an image capture:
•
The SE4710 stops outputting image.
•
The host sends the Acquisition Stop command.
•
The host sends the Aim Off command.
•
The host sends the Illumination Off command.
•
The host goes back to Acquisition Mode Barcode Decode.
•
The SE4710 (when all conditions are met) enters Reduced Power mode.