Motorola PPC/CPCI-690, Reference Manual, Page: 84 / 176

Booting the Board PowerBoot
4 - 10 PPC/CPCI-690
8. Enter md command to display contents of programmed user flash
PowerBoot> md f4000000
f4000000: 46 4f 52 43 45 20 46 4f 52 43 45 20 46 4f 52 43
f4000010: 45 20 46 4f 52 43 45 20 46 4f 52 43 45 20 46 4f
f4000020: 52 43 45 20 46 4f 52 43 45 20 46 4f 52 43 45 20
f4000030: 46 4f 52 43 45 20 46 4f 52 43 45 20 46 4f 52 43
f4000040: 45 20 46 4f 52 43 45 20 46 4f 52 43 45 20 46 4f
f4000050: 52 43 45 20 46 4f 52 43 45 20 46 4f 52 43 45 20
f4000060: 46 4f 52 43 45 20 46 4f 52 43 45 20 46 4f 52 43
f4000070: 45 20 46 4f 52 43 45 20 46 4f 52 43 45 20 46 4f
f4000080: 52 43 45 20 46 4f 52 43 45 20 46 4f 52 43 45 20
f4000090: 46 4f 52 43 45 20 46 4f 52 43 45 20 46 4f 52 43
f40000a0: 45 20 46 4f 52 43 45 20 46 4f 52 43 45 20 46 4f
f40000b0: 52 43 45 20 46 4f 52 43 45 20 46 4f 52 43 45 20
f40000c0: 46 4f 52 43 45 20 46 4f 52 43 45 20 46 4f 52 43
f40000d0: 45 20 46 4f 52 43 45 20 46 4f 52 43 45 20 46 4f
f40000e0: 52 43 45 20 46 4f 52 43 45 20 46 4f 52 43 45 20
f40000f0: 46 4f 52 43 45 20 46 4f 52 43 45 20 46 4f 52 43
More (cr) ?
PowerBoot>
Partitioning the Hard
Disk PowerBoot only supports the Ramix IDE PMC modules with hard disk. In
order to boot from ATA/IDE, the hard disk must have either a PREP or a
DOS 4.0 partition.
Autoboot
There are three possibilities to boot the board:
• Via the autoboot command
The board boots directly without executing a board reset
• Via the autoboot option in setboot
The board boots automatically after a reset has been executed
• Via the go option in setboot
The image loaded to the flash can directly be executed