Installing the Transition Module and P2 Adapter
http://www.mcg.mot.com/literature
2-5
2
Installing the Transition Module and P2 Adapter
Install the MVME761 transition module and P2 adapter in the system
chassis. The P2 adapter is required because the P2 connector on the
transition module is not compatible with the P2 connector on the chassis
backplane.
Use ESD
Wrist Strap
Motorola strongly recommends that you use an antistatic wrist strap and a
conductive foam pad when installing boards in a system chassis.
Electronic components, such as disk drives, computer boards, and memory
modules, can be extremely sensitive to ESD. Place the board flat on a
grounded, static-free surface, component-side up. Do not slide the board
over any surface.
If an ESD station is not available, you can avoid damage resulting from
ESD by attaching the ESD wrist strap to an unpainted metal part of the
system chassis.
Install the MVME761-0x1 in the system chassis per the
, which shows the cabling and connections within
the chassis.
!
Caution
An MVME2600/MVME2700/MVME3600/MVME4600
module that is designed for use with an MVME712M
Transition Module will be damaged if you use it with an
MVME761-0x1 Transition Module.
!
Caution
Connecting modules while power is applied may result in
damage to components on the module.
!
Warning
Dangerous voltages, capable of causing death, are present in
this equipment. use extreme caution when handling, testing,
and adjusting.
