1-4
Computer Group Literature Center Web Site
Hardware Preparation and Installation
1
Guidelines for Unpacking
If the shipping carton is damaged upon receipt, request that the carrier’s
agent be present during the unpacking and inspection of the equipment.
Caution
Caution
When unpacking, avoid touching areas of integrated circuitry; static
discharge can damage circuits.
Refer to the packing list and verify that all items are present. Save the
packing material for storing and reshipping of equipment.
Installation Preliminaries
This section applies to all hardware installations you may perform that
involve the MVME167P board.
Use ESD
Wrist Strap
ESD
Motorola strongly recommends the use of an antistatic wrist strap and a
conductive foam pad when you install or upgrade the board. Electronic
components can be extremely sensitive to ESD. After removing the board
from the chassis or from its protective wrapper, place the board flat on a
grounded, static-free surface, component side up. Do not slide the board
over any surface.
Initialize the system clock.
Examine and/or change
environmental parameters.
CNFG and ENV command descriptions in
.
Program the board as needed for your
applications.
MVME1XP Single Board Computers Programmer’s
Reference Guide, listed in
.
Table 1-1. Startup Overview (continued)
What you need to do...
Refer to...
