1-22
Computer Group Literature Center Web Site
Hardware Preparation and Installation
1
Notes
For the MCECC memory model to be enabled, the MC2
emulation must be disabled. You disable the MC2 memory
model by setting the MC2 DRAM size select switch (S3) to
110 (Off/Off/On). Refer to
for further
details.
The factory default setting for S6 is 16MB (On/Off/On). If
you modify the switch settings, you will need to execute
env;d <CR> so that the firmware recognizes the new
memory defaults.
Installation Instructions
This section covers:
❏
Installation of IndustryPacks (IPs) on the MVME162P2
❏
Installation of the MVME162P2 in a VME chassis
❏
System considerations relevant to the installation. Ensure that an
EPROM device is installed as needed. Before installing
IndustryPacks, ensure that the serial ports and all header jumpers
and configuration switches are set as appropriate.
Table 1-10. MCECC DRAM Size Settings
S6
Segment 1
S6
Segment 2
S6
Segment 3
MCECC
DRAM Size
ON
ON
ON
4MB
ON
ON
OFF
8MB
ON
OFF
ON
16MB
ON
OFF
OFF
32MB
OFF
ON
ON
64MB
Summary of Contents for MVME162P-242
