Motorola MVME162P-242, Installation And Use Manual

Page: 133 / 134

http://www.motorola.com/computer/literature IN-5
I
N
D
E
X
programmable tick timers 4-16
Q
QIC-02 streaming tape drive D-4
R
regulatory compliance A-4
related specifications E-3
relative humidity A-1
remote control/status connector (J2) 4-18 ,
5-2
RESET switch 4-18
resetting the system 2-1 , 2-12
RF emissions 1-24
minimizing A-4
ROMboot process 2-10
S
safety procedures 1-4
SCC (serial communications controller) 2-8
SCSI
common command set (CCS) devices
D-2 , D-4
controller (53C710) 4-15
direct access devices D-2
interface 4-15
sequential access devices D-2
signals 5-5
termination 4-15
termination header (J12) 1-8
terminator configuration 4-15
SD command 2-14
SDRAM (shared DRAM)
options 4-7
sequential access devices D-4
serial
communication parameters 2-4
communications controller (SCC) 2-8
communications interface 1-27 , 4-13 ,
5-4
connectors 4-18
ports 2-7
Set Bug/Operating System Environment
(ENV) firmware command 3-11
setting date and time 2-8 , B-2
shielded cables A-4
size of base board A-1
slave address decoders, VMEbus 3-16
snoop control 1-18
software-programmable hardware interrupts
4-16
software-readable switch (S4) 1-16
specifications
MVME162P2 A-1
related E-3
SRAM (static RAM)
backup power source selection (J14)
1-10
battery options 4-9
options 4-8
startup overview 1-1
startup problems, solving B-1
static variable space (firmware) 3-4
storage temperature A-1
streaming tape drive D-4
switch settings, modifying 1-16 , 1-22
switches, configuration
S3 (MC2 DRAM size) 1-15
S4 (EPROM/Flash selection) 1-17
S5 (Flash Write Enable mode) 1-20
S5 (IP DMA snoop control) 1-18
S5 (IP reset mode) 1-19
S6 (MCECC DRAM size) 1-21
switches, front panel 2-1
switching directories 2-14
system
considerations 1-25
console setup 2-7
controller function 2-5
controller jumper (J1) 1-7
reset 2-12
startup 2-3
System Fail (SYSFAIL*) signal 2-10