Motorola MK1200, Product Reference Manual

Page: 37 / 232

Installation 2 - 7
Connecting the MK1200
The MK1200 communication interfaces include both wired and wireless solutions:
•
Wired Ethernet (10 Base-T cable)
• Power via AC outlet (see below)
• Power via Symbol’s BiasT Power-Over-Ethernet (see page 2-8 )
•
Wireless Ethernet (11Mb RF)
•
Wired RS-232 (serial cable) (see page 2-9 ).
To configure the communications interfaces, see Chapter 4, Remote Device Manager . To access the Windows
®
CE Desktop, see Accessing the Windows® CE Desktop on page 7-7 .
AC Power Supply
The Symbol universal AC power supply has a positive center pin and the outer tab is ground. It is compatible with:
•
120V 60 Hz (North America)
•
230V 50 Hz (International excluding Japan)
•
100V 50/60 Hz (Japan).
Wired Ethernet Connection
With a wired Ethernet connection, Ethernet-enabled MK1200 models are powered either using the MK1200’s
Symbol AC power supply, or by Power-Over-Ethernet through the Ethernet cable.
Wired Ethernet: Power via AC Outlet
The MK1200 communicates to the host via a 10 Base-T Ethernet cable and receives power via a Symbol AC
power supply.
1.
Insert the power supply’s barrel connector into the MK1200’s power port. See Figure 1-3 on page 1-5 .
2.
Route the power cable.
3.
Plug the Symbol AC power supply into a wall outlet.
4.
Connect the Ethernet cable to the LAN port on the MK1200. See Figure 1-3 on page 1-5 . Ensure the Ethernet
cable is terminated according to Table 2-2 on page 2-11 .
5.
Plug the other end of the Ethernet cable into the host system’s LAN port.