Motorola MC75A, User Manual

Page: 171 / 232

Accessories 7 - 27
Cables
This section describes how to set up and use the cables. The cables are available with a variety of connection
capabilities.
The following communication/charge cables are available:
•
Serial (RS232) Charge cable (9-pin D female with power input receptacle)
•
USB Client Charge cable (standard-A connector and a barrel receptacle for power)
•
Auto charge cable
•
DEX cable
•
Modem inverter cable
•
Charge only cable.
The following printer cables are available directly from Zebra:
•
O’Neil Printer cable
•
Zebra Printer cable.
Figure 7-29
Cables
Communication/charge cables:
•
Provide the MC75A with operating and charging power when used with the approved power supply.
•
Synchronize information between the MC75A and a host computer. With customized or third party software,
it can also synchronize the MC75A with corporate databases.
•
Provide serial connection through the serial pass-through port for communication with a serial device, such
as a host computer. For communication setup procedures, refer to the
MC75A Integrator Guide .
•
Provide USB connection through the USB pass-through port for communication with a USB device, such as
a host computer. For communication setup procedures, refer to the
MC75A Integrator Guide .
Dedicated printer cables provide communication with a printer.
Battery Charging and Operating Power
The communication/charge cables can charge the MC75A battery and supply operating power.
To charge the MC75A battery:
1.
Connect the communication/charge cable power input connector to the approved power source.