Motorola MC7090CN, User Manual

Page: 88 / 130

4 - 12 MC7090CN User Guide
Using the MSR
The MSR3000 sample application illustrates how an application handles MSR input (refer to Applications
User’s Guide ).
To use the MSR:
1.
Attach the MSR to the EDA.
2.
Power on the EDA.
3.
Install the MC70 Demo application onto the EDA. The demo is available with the SMDK. See the
MC7090CN Integrator Guide for more information.
4.
Tap Start - MC70 Demo - Test Apps - MSR MC70 or MSR Cameo to start the sample application.
5.
Swipe the magnetic stripe card through the MSR, with the magnetic stripe on the card facing down. Swipe
the card in either direction, from left to right or from right to left. For best results, gently press down on the
card while swiping to ensure contact with the bottom of the reader.
Figure 4-12
Magnetic Stripe Card Swiping
TRG7000 Trigger Handle
The TRG7000 Trigger Handle pistol grip accessory adds a gun-style handle with a scanning trigger to the EDA.
It increases comfort when using the EDA in scan-intensive applications for extended periods of time. The
TRG7000 is intended for use with MC70 WLAN/PAN configurations.
Install the cleat onto the EDA before using the trigger handle. For cleat installation and communication setup
procedures refer to the
MC7090CN Integrator Guide .