Motorola MBX Series, Installation And Use Manual

Page: 35 / 116

Replacing Lithium Batteries
http://www.motorola.com/computer/literature 1-15
1
!
Warning
Warning Lithium batteries incorporate flammable materials such as lithium and
organic solvents. If lithium batteries are short-circuited or exposed to high
temperature or pressure, they may burst open and ignite, possibly resulting
in injury and/or fire. When dealing with lithium batteries, carefully follow
the precautions listed below in order to prevent accidents.
❏
Do not short-circuit.
❏
Do not disassemble, deform, or apply excessive pressure.
❏
Do not heat or incinerate.
❏
Do not apply solder directly.
❏
Do not use different models, or new and old batteries together.
❏
Do not charge.
❏
Always check proper polarity.
!
Caution
Caution Danger of explosion if battery is replaced incorrectly.
Replace battery only with the same or equivalent type recommended by the
equipment manufacturer. Dispose of used batteries according to local
regulations and manufacturer’s instructions.
Caution
Caution Avoid touching areas of integrated circuitry; static discharge can damage
circuits.
Use ESD
Wrist Strap
ESD
Attach an ESD strap to your wrist. Attach the other end of the ESD strap
to an electrical ground. (Note that the system chassis may not be grounded
if it is unplugged.) The ESD strap must be secured to your wrist and to
ground throughout the procedure.
1. To remove the battery from the module, carefully pull the battery from
the socket.
2. Before installing a new battery, ensure that the battery pins are clean.