Getting Started
11
ENGLISH
5.
Press and hold the
P
POWER ON/OFF button until the progress bar
finishes scrolling, to turn OFF the Parent Unit.
NOTE
The battery icon
turns RED to indicate that the battery is low, and it emits
a beep every 16 seconds. The battery needs to be recharged. The battery pack
takes about 12 hours to charge fully.
When charging
1.
During charging, the battery icon at the top right of the screen indicates
that it is charging. If the Parent Unit is turned off while charging, a plug icon
is displayed for 5 seconds, followed by a battery icon for 45 seconds. The
Blue LED at the top left corner lights up to indicate that the power adapter
is plugged in.
2.4
Registration (Pairing)
The Baby Unit is pre-registered to your Parent Unit. You do not need to register
it again unless the Baby Unit loses its link with the Parent Unit.
To re-register your Baby Unit, or register a new Baby Unit, follow the procedure
below:
1.
Press the
M
button on the Parent Unit and the menu bar will pop up.
2.
Press the
<
LEFT button or
>
RIGHT button until
is highlighted.
The
menu will pop up.
3.
Press the
+
UP button or
-
DOWN button to select
, and press the
OK
button to confirm.
will pop up.
4.
Press the
+
UP button or
-
DOWN button to select the desired Camera
and press the
OK
button to start searching for a camera unit. The green
audio level LED will flash rapidly while searching.
5.
Press the
OK
button to confirm.
6.
Press and hold the
PAIR
button underneath the Baby Unit until the Parent
Unit finds the camera, beeps and the video from the camera appears.
NOTE
If a particular Baby Unit was registered previously, registering this current Baby
Unit again will overwrite the old registration.
0
