10
Getting started
NOTE
Once the baby and parent units are switched on, the display on the parent
unit will show the video captured by the baby unit. When the Voice Activation
mode is on, the screen will turn off after a few seconds if the sound near the
baby unit drops below the Voice Activation threshold.
When there is no connection or the units are out of range, the
icon on
the LCD display will flash and the parent unit will beep continuously. Move
the parent unit closer to the baby unit until the link is re-established.
2.5
Registration
The Baby monitor is pre-registered to your Parent unit. You do not need
to register it again unless the Baby unit loses its link with the Parent unit.
To re-register your Baby unit, or register a new Baby unit, follow the
procedure below:
1.
Switch off the Baby unit
2.
Press
m
button on the Parent unit until
Registration
appears on
display screen.
3.
Press
m
button to confirm the selection and
1
will enter the
registration mode and appears on display screen for 15 seconds.
4.
Switch the Baby unit ON to enter the registration mode. The power
LED on the baby unit flashes quickly for approximately
3
seconds.
The registration is completed when
1… OK
appears for 3 seconds and
captures the video from the baby unit’s camera on display screen of the
parent unit.
If the registration fails then
1… X
appears on display screen for 3
seconds then both parent and baby units return to normal mode.
NOTE
If a particular Baby unit had been registered already, register this current
Baby unit again will over-write the old registration.
