Motorola Malux MTM5400 Series, Installation Manual

Page: 60 / 134

Figure 21: Ethernet Cable (PMKN4176_, PMKN4177_, and PMKN4178_)
1 1
NOTICE: For PMKN4135_, the open-end wire at the "CH" end shall be terminated with the in-
box RJ50 plug based on the Ethernet Cable Pin Diagram . After routing the transceiver to the
Control Head, use a 10P10C Crimping Tool to crimp the RJ50 plug to the open end of the
cable.
Number Description
1 EEH mark
WARNING: Using
the ‘EEH’ and
‘CH’ marks ensure
the Ethernet Ca-
bles are connect-
ed in the right
way.
2 CH mark
NOTICE: Requires three (3) Ferrite Clamps,
Part Number 91012044001. Manually install
all Ethernet cables. Install clamps on the CH
end of the cable with two turns of wire
around each clamp.
4.4.2
Installing the Remote Mount Ethernet Control Head (eCH) onto the
Remote Mount Trunnion
When and where to use: Follow these steps to install the Remote Mount Enhanced Control Head
onto the Remote Mount Trunnion.
Procedure:
1 Slide the Remote Mount Enhanced Control Head onto the mounting trunnion until it snaps into
place.
2 Tighten the screws at both sides of the trunnion. After a few turns, tilt the control head for an
optimum view of the display. Then, complete the tightening of the screws.
68015000181-LB
Chapter 4: Radio Installation
60 Send Feedback