Motorola LEX L10i, User Manual

Page: 172 / 186

12.5
Cleaning the Interface Connector
When and where to use: Use this procedure To clean the contacts of the interface connector on LEX
L10i.
Procedure:
1 Power off the device.
2 Dip the cotton portion of the cotton-tipped applicator in isopropyl alcohol.
3 Rub the cotton portion of the cotton-tipped applicator along the contacts of the interface
connector. Slowly move the applicator back-and-forth from one side of the connector to the
other.
4 If grease and other dirt can be found on other areas of the cradle, remove using a lint-free cloth
and alcohol.
5 Allow few minutes (depending on ambient temperature and humidity) for the alcohol to air dry
before powering on the device.
Return to Process
Maintenance and Troubleshooting on page 169
12.6
Cleaning the Battery Contacts
When and where to use: Perform this procedure to clean the battery connectors.
Procedure:
1 Remove the main battery from device.
2 Dip the cotton portion of the cotton-tipped applicator in isopropyl alcohol.
3 Gently, rub the cotton portion of the cotton-tipped applicator back-and-forth across the contacts.
Do not leave any cotton residue on the contacts.
4 Use the cotton-tipped applicator dipped in alcohol to remove any grease and dirt near the
contacts area.
5 Use a dry cotton-tipped applicator and repeat steps 4 and 5 at least three times.
CAUTION: Do not point nozzle at yourself and others. Ensure that the nozzle or tube is
away from your face.
6 Spray compressed air on the connector area by pointing the tube/nozzle about ½ inch away
from the surface.
7 Inspect the area for any grease or dirt, repeat if required.
Return to Process
Maintenance and Troubleshooting on page 169
MN002347A01-B
Chapter 12: Maintenance and Troubleshooting
172 Send Feedback