Motorola KVL 4000, User Manual

Page: 175 / 236

7.4 Managing OTAR Configuration Parameters in Target Devices
Procedure Steps
1
Select
Configure a radio
on the KVL main screen.
Step result: You are prompted to connect a target device.
If a device is already connected, this prompt is skipped. If a device becomes disconnected, you
are returned to the prompt.
2 Connect the target device. (See 1.4.4.1 Connecting the KVL to a Radio or Another Target Device, page 1-13 .)
Step result:
A
connected
tone is played and a list of available options appears.
3 Select Keysets .
Step result: A list of available keysets appears, with the active keyset highlighted and indicated with a check
mark.
4 Tap the list item for the keyset which you want to set as active.
Step result:
If the change takes more than 1 second, a progress animation appears while the keyset is being
changed. Otherwise, the keyset is changed instantly, the completed tone is played, and the list item for the new
keyset receives a check mark.
5 Disconnect the target device and tap Done on the consecutive screens to return to the KVL main screen.
7.4 Managing OTAR Configuration Parameters in
Target Devices
The following parameters are required by target devices in order to operate within an OTAR system:
• Target's RSI
• KMF RSI
• MNP
In most cases, these parameters are loaded into the target devices automatically by the KVL during the initial
Store and Forward update through the KMF. The KVL has the capability of viewing these parameters, as well as
loading new parameters into target devices (if necessary).
7.4.1 Viewing the Target's MNP
You can connect the KVL to a target device (such as a radio, DIU, or RNC) and view the MNP currently stored in
the device.
6871018P37-F - January 2013
7-19