8
1.
Hold down the Power Button for at least four seconds
until the HC700-i screen turns off.
2.
Remove the HC700-i hand-strap (see Figure 4).
3.
Press the battery snap
on the battery (see Figure 4) and
pull away the battery from the HC700-i.
4.
Insert a fresh battery, bottom end first, into the battery
compartment.
5.
Carefully, press the battery top downward until it clicks
and locks in place.
Press the Power Button - the HC700-i is now ready for use.
Battery Safety
The battery or HC700-i may carry warning symbols, defined
as follows:
Important safety information will follow.
Your battery or HC700-i should not be disposed of in a
fire.
To prevent injury or burns:
•
USE ONLY SPECIFIED BATTERIES AND CHARGERS - RISK OF EXPLO-
SION IF BATTERY IS REPLACED BY AN INCORRECT TYPE!
•
DO NOT DISPOSE OF ANY BATTERIES IN FIRE, AS THEY MAY
EXPLODE!
•
DO NOT PUNCTURE OR ALLOW METAL TO CONTACT THE BATTERY
CONTACTS
•
DO NOT DISPOSE OF IN WATER
•
DO NOT DISASSEMBLE
Battery Maintenance
The performance of the battery depends on the way the bat-
tery is treated. Therefore, to comply with Motorola Warranty
for batteries and to assure high performance and a long life
for the rechargeable battery, please read and follow the bat-
tery maintenance instructions described in the following sec-
tions.
Enhanced IMD Users.book Page 8 Tuesday, September 26, 2006 2:17 PM
Summary of Contents for HC700-i F3130A
