Motorola G30, Technical Information

Page: 32 / 70

Initial Setup
14 G30 Developer’s Kit December 15, 2009
A diagram on the cover indicates how to insert the SIM card.
Figure 2-7: SIM Tray
Note: When using a G30 with an Embedded SIM, verify the following:
1. A SIM card is not inserted into the SIM tray.
2. G30 "ESIM_RST" and "SIM_RST" signals are shorted on the EVB. This could be
done by manually shorting P100 header pins 56 and 44.
Antenna
To Attach the Antenna
•
Screw the supplied antenna into the antenna base, located at the bottom-right corner on top of
the Developer's Kit.
The Developer's Kit arrives configured to operate with its on-board internal antenna. The
EXT ANT and INT ANT connectors are connected together using an external RF cable, on
the board's right side ( Figure 2-2 and Figure 2-3 ) .
Power Up
Important: You must turn the Developer Board power on before turning on the G30.
To Turn on the Power
1. Turn on the Developer Board power by switching the power On/Off switch (S200) to ON
( Figure 2-5 ).
The Developer Board power On/Off switch (labeled Power ) is located at the rear of the
Developer Board.
The Developer Board power indicator LED is lit.
2. Turn on the G30 power by pressing the On/Off pushbutton (S110) for at least 0.5 seconds
( Figure 2-8 ).
The G30 power On/Off pushbutton is located at the front of the Developer Board.
SIM Tray