Motorola ET1, Integrator Manual

Page: 95 / 184

CHAPTER 6 WWAN CONFIGURATION
In order to use the WAN radio for data communication, the ET1N2 must be activated on the service provider’s
network. By default, the ET1N2 is configured for a GSM network. To activate on a CDMA network, manual
configuration is required.
Activation
The ET1N2 supports both GSM and CDMA network.
GSM Activation
GSM networks require a SIM card obtained from the service provider. Install the SIM card before using the
ET1N2. When the ET1N2 turns on it automatically configures for the network. If the SIM card requires a PIN,
the PIN screen appears. Enter the PIN and touch OK.
CDMA Activation
Prior to using the ET1N2 on a CDMA network, the ET1 must be registered with the service provider. Contact
the service provider to set up an account and provide the MEID number (located under the battery).
By default, the ET1N2 is configured for a GSM network. To activate on a CDMA network:
1.
Touch > Settings > Wireless & networks .
2.
Touch Mobile networks > Technology preferences > Network mode .
3.
In the Network mode menu, select either Sprint or Verizon . The ET1 switches the modem firmware and
the Activation Dialog box appears.
4.
Touch Activate . The ET1N2 begins the activation process. If the activation is unsuccessful, contact the
service provider.