Motorola ET1, Integrator Manual

Page: 65 / 184

DataWedge Configuration 4 - 9
Enabled
Enables or disables this plug-in. A check in the checkbox indicates that the plug-in is enabled.
Scanner Selection
Configures which scanning device to use for bar code data capture when the profile is active.
•
Auto - The software automatically determines the best scanning device. If a Scan Module or Scan/MSR
Module is installed on the ET1, then the 2D imager is selected. Otherwise the camera is selected.
•
Camera scanner - Scanning is performed with the rear-facing camera.
•
2D Imager - Scanning is performed using the installed Scan or Scan/MSR module.
Decoders
Configures which bar code decoders are enabled or disabled. For best performance disable all unnecessary
decoders.
Touch Decoders . The Barcode input screen appears. A check in the checkbox indicates that the decoder is
enabled. By default the most commonly used decoders are enabled (shown below with an asterisk). The
supported decoders are:
•
UPC-A* UPC-E0* EAN-13*
•
EAN-8* Code 128* Code 39*
•
Interleaved 2 of 5 GS1 DataBar* GS1 DataBar Limited
•
GS1 DataBar Expanded* Datamatrix* QR Code*
•
PDF417* Composite AB Composite C
•
MicroQR Aztec* Maxicode*
•
MicroPDF USPostnet USPlanet
•
UK Postal Japanese Postal Australian Postal
•
Canadian Postal Dutch Postal US4state FICS
•
Codabar* MSI Code 93
•
Trioptic 39 Discrete 2 of 5 Chinese 2 of 5
•
Korean 3 of 5 Code 11 TLC 39
•
Webcode Matrix 2 of 5 UPC-E1
Touch to return to the previous screen.
Decoder Params
Use Decode Params to configure individual decoder parameters. Touch Decode Params . The Decode
params screen appears.
Touch the decoder parameter to modify.