Motorola ET1, Integrator Manual

Page: 24 / 184

1 - 6 ET1 Enterprise Tablet Integrator Guide
2.
Touch Battery Swap . The Scan LED lights red.
3.
Wait until the Scan LED turns off.
4.
Press thumb against the side of the ET1 and battery. Using the index and middle fingers, move the battery
release latch toward thumb.
5.
Pull the battery out of the battery compartment.
Figure 1-3
Removing the Battery
6.
Align the tracks on the side of the replacement battery with the rails in the battery compartment.
7.
Push the battery in until the battery release latch snaps into place.
8.
Press the Power button to turn on the ET1.
Resetting the ET1
There are four reset functions:
•
Soft Reset
•
Hard Reset
•
Enterprise Reset
•
Factory Reset.
Soft Reset
Perform a Soft Reset when applications become unresponsive.
To perform a Soft Reset:
1.
Press and hold the Power button until the Device options menu appears.
2.
Touch Reset .
Hard Reset
Perform a Hard Reset when the ET1 stops functioning. To perform a Hard Reset simultaneously press and
release the Left Scan/Action, Right Scan/Action and Power buttons on the back of the ET1.
Battery Release Latch