Motorola DS9208, Product Reference Manual, Page: 48 / 440

4 - 2 DS9208 Product Reference Guide
Scanning Sequence Examples
In most cases, scanning one bar code sets the parameter value. For example, to set the beeper tone to high,
scan the
High Frequency (beeper tone) bar code listed under Beeper Tone on page 4-6 . The digital scanner
issues a fast warble beep and the LED turns green, signifying a successful parameter entry.
Other parameters, such as Serial Response Timeout or Data Transmission Formats , require scanning
several bar codes. See these parameter descriptions for this procedure.
Errors While Scanning
Unless otherwise specified, to correct an error during a scanning sequence, just re-scan the correct parameter.
User Preferences/Miscellaneous Options Parameter Defaults
Table 4-1 lists defaults for user preferences parameters. To change the default values, scan the appropriate
bar codes in this guide. These new values replace the standard default values in memory. To recall the default
parameter values, scan the
Set Default Parameter on page 4-4 .
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 4-1
User Preferences Parameter Defaults
Parameter
Parameter
Number
Default
Page
Number
User Preferences
Set Default Parameter N/A Set Defaults 4-4
Parameter Bar Code Scanning 236 Enable 4-5
Beep After Good Decode 56 Enable 4-5
Beeper Tone 145 Medium 4-6
Beeper Volume 140 High 4-7
Volume Adjustment Trigger Timeout 403 5.0 Sec 4-8
Beeper Duration 628 Medium 4-9
Suppress Power-up Beeps 721 Do not suppress 4-9
Low Power Mode 128 Disable 4-10
Time Delay to Low Power Mode 146 1 Hour 4-11
Trigger Mode 138 Presentation 4-13
Trigger Aiming Pattern 306 Enable 4-14
Presentation Aiming Pattern 590 Disable 4-15
Momentary Trigger Mode Timeout 237 5 sec 4-16
Motion Detect Range 827 Full 4-17