Motorola DS4208, Product Reference Manual, Page: 66 / 364

4 - 14 DS4208 Digital Scanner Product Reference Guide
Decode Session Timeout
Parameter # 88h
This parameter sets the maximum time decode processing continues during a scan attempt. It is programmable in
0.1 second increments from 0.5 to 9.9 seconds. The default timeout is 9.9 seconds.
To set a Decode Session Timeout, scan the bar code below. Next, scan two numeric bar codes from Appendix D,
Numeric Bar Codes that correspond to the desired on time. Enter a leading zero for single digit numbers. For
example, to set a Decode Session Timeout of 0.5 seconds, scan the bar code below, then scan the 0 and 5 bar
codes. To correct an error or change the selection, scan Cancel on
page D-2 .
Timeout Between Decodes, Same Symbol
Parameter # 89h
Use this option in presentation mode or Continuous Bar Code Read to prevent the beeper from continuously
beeping when a symbol is left in the digital scanner’s field of view. It is programmable in 0.1 second increments
from 0.0 to 9.9 seconds. The default interval is 0.5 seconds.
To select the timeout between decodes for the same symbol, scan the bar code below, then scan two numeric bar
codes from
Appendix D, Numeric Bar Codes that correspond to the desired interval, in 0.1 second increments.
NOTE Decode Session Timeout cannot be less than or equal to either Timeout Between Decodes, Same Symbol
or Timeout Between Decodes, Different Symbols.
Decode Session Timeout
NOTE Timeout Between Decodes, Same Symbol cannot be greater than or equal to the Decode Session
Timeout.
Timeout Between Decodes, Same Symbol