Motorola DIMETRA MTS 2, Installation, Configuration And Basic Service Manual

Page: 449 / 517

MTS 2 and MTS 4 Installation, Con
fi
guration and Basic Service Manual How to Install
Procedure 15-4 How to Add an Additional Base Radio to MTS 4 (Continued)
Figure 15-8 TX Connectors on Cavity Combiner
5
Attach the Ethernet cable to the appropriate BR input of the Site Controller according to the
scheme below:
# Note Part no Cable type From To
2 If BR2 3066544B02 Ethernet
cable
BR2 / SC1 SC1 / BR2
6 If BR3 3066544B04 Ethernet
cable
BR3 / SC1 SC1 / BR3
11 If BR4 3066544B05 Ethernet
cable
BR4 / SC1 SC1 / BR4
Index numbers in table above refer to cable connections shown in Figure 15-11 .
At this stage only connect the cable to the Site Controller.
If the Ethernet cable is being wired from a Base Radio in one Module Cage to a Site
Controller in another Module Cage, the Ethernet cable is to be drawn outside of
the Module Cage.
6
Insert the additional Base Radio by aligning the side rails with the appropriate rail guides inside
the Base Radio chassis.
7
Gently push the additional module completely into the Base Radio chassis assembly using
the module handle(s). Be careful not to damage any of the cables previously connected when
pushing the Base Radio into position.
8
Secure the additional module using two TORX screws. Tighten the screws to a torque of 2.7 Nm.
6802800U74-N September 2009
15-19