Motorola DIMETRA MTS 2, Installation, Configuration And Basic Service Manual

Page: 346 / 517

Base Radio Replacement Process Chapter 10: Base Radio
Base Radio Replacement Process
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
For a list of available Field Replaceable Units (FRUs), see Appendix A, "Field Replaceable Units (FRUs)" .
Process 10-1 Base Radio Replacement Process
1
Remove the Base Radio module, see Procedure 10-1 .
2
Reinstall the new Base Radio, see Procedure 10-2 .
3
Perform the procedures from the "Base Radio Con
fi
guration and Veri
fi
cation" section in
Chapter 6, "Con
fi
guration and Testing" . Follow Process 6-3 .
4
If Encryption and/or Authentication is used, perform Process 8-4 .
Electrostatic Discharge Precaution
The Base Radio circuitry contains many CMOS and other electrostatic discharge sensitive devices. Take precau-
tionary measures to prevent damage of Base Radio modules by static discharge when servicing the equipment.
Observe the following additional precautions:
•
Wear a wrist strap (Motorola Part No. 4280385A59 or equivalent) at all times when
servicing the Base Radio to minimize static build up.
•
A jack is provided at top left of module cage marked with the ground symbol.
•
Keep spare modules in factory packaging for transporting. When shipping
modules, always pack in original packaging.
For more information, see Appendix C
10-10
6802800U74-N September 2009