Motorola CPCI-9120, Reference Manual

Page: 59 / 168

IXP/CPCI-9120 Board Installation Installation
58 IXP/CPCI-9120
Installation Procedure
Before installing IXP/CPCI-9120, observe the following:
Caution Only install the board under hot-swap conditions if the board is to be operated in slots
for which hot swap is explicitly permitted by the system documentation (in most hot-
swap systems, only Peripheral Slots are hot-swappable).
Before touching integrated circuits, make sure that you are working in an ESD-safe envi-
ronment.
The installation process depends upon the system that the board is to be installed.
Installation in Basic Hot Swap System
1. Ensure that the board has the desired accessories and all switches are appropriately
configured.
2. Ensure that IXP/CPCI-9120 is inserted into a slot that does not have an RTB
already installed.
3. Insert board into powered system by placing the top and bottom edges of the board
in the card guides of the chassis as shown in Figure 8.
4. Check that the top and bottom injector/ejector handles are in the outward position
as shown by arrows in Figure 7.
5. Slide the board into the chassis until you feel resistance (approximately 1/4 inch
short of full insertion). The arrow in Figure 8 shows you the direction of required
movement.
6. Simultaneously move the top and bottom injector/ejector handles to the inward
position.
7. Verify that the board is seated properly.
8. Tighten the captive screws that secure the board to the chassis. A zoomed view of
the screw on the injector/ejector handle is shown in Figure 9.
9. Perform the software connection according to system documentation.