Motorola CompactPCI CPX2000 Series, Installation And Reference Manual

Page: 60 / 136

Removing and Installing the CPU Transition Module
http://www.motorola.com/computer/literature 3-19
3
Removing and Installing the CPU Transition
Module
This section tells you how to remove and replace a transition module. The
transition module mounts at the rear of the chassis.
Tools You Need
You need a number 1, Phillips head screwdriver, with a four inch shaft.
Removing the CPU Transition Module
Use this procedure to remove the CPU Transition Module from the chassis.
!
Caution
Set the main power switch on the front of the chassis to OFF
(O). Set the power supply switch(es) to OFF (O)
(CPX2208DC and CPX2408 only).
1. Set the main power switch to OFF (O).
2. Set the power supply switch(es) to OFF (O) (CPX2208DC and
CPX2408 only).
3. Disconnect the power cord(s) from the source to make sure that you
remove power from the system.
!
Warning
System may have multiple power supply cords. Disconnect all
power supply cords before servicing.
4. Remove the six screws from the rear panel covering the transition
module cage (CPX2108 only).
5. Remove the panel (CPX2108 only).