Motorola CA50, Developer & User Manual, Page: 214 / 542

8 - 14 CA50/UCA Client & Server Developer & User Guide
Device Settings
This section captures the device settings such as backlight and RF sample time.
Figure 8-17
Device Settings
Table 8-6
Logging Settings
Field Description
Off No logging.
Info Logs high level information such as device and server IP addresses.
Error Logs all error messages along with information messages.
Warn Logs information, error and warning messages.
Debug Logs all messages
Table 8-7
Device Settings
Field Description
AC Backlight On Key Press Press key to turn on the backlight (device is in the cradle).
AC Backlight Timeout Sets the time in seconds that the backlight stays on (device is in the cradle).
AC Power Check Interval Sets the time in seconds that the device uses to check if it is in the cradle.
Min Signal Strength Sets the minimum RF signal strength to be connected (the numbers are negative; the
larger the negative number, the weaker the signal, e.g., -70 is weaker than -60).
RF SampleTime Sets the time in seconds for the RF signal strength sampling.
Good RF SampleThreshold Sets the number of times the RF sample signal strength must be above the minimum
signal strength before the bad sample count is reset.
Bad RF SampleThreshold Sets the number of times the RF sample signal strength must be below the minimum
signal strength before the Network Connection Lost message displays.
Notif Msg Vibrate Cycle Count The number of times the device should vibrate on receipt of notification message.