![Motorola BSR 2000 Installation Manual Download Page 36](http://html.mh-extra.com/html/motorola/bsr-2000/bsr-2000_installation-manual_245551036.webp)
BSR 2000 Installation Guide
2-14
MGBI
526359-001
Figure 2-9 Connecting a Cable to the T1/E1 BITS Interface Port
Connecting Coaxial Cables to the BSR 2000
The BSR 2000 has one downstream channel and four upstream channels. The ports
for these channels, shown in
, are located on the BSR 2000 rear panel.
Connecting a Coaxial Cable to the Downstream Channel Port
To connect cables to the downstream channel port, follow these steps and refer to
1.
Identify the downstream channel connector (DS0) on the BSR 2000 rear panel.
The port is color-coded with an orange label.
2.
Insert the center conductor of the downstream channel cable into the small
opening at the center of the BSR 2000 downstream channel connector.
3.
Secure the connection by screwing the outside cable connector housing onto the
BSR 2000 downstream connector until finger tight; then using a wrench, tighten
the connector one-quarter turn (15 in.-lbs when using a torque wrench).
Connecting Coaxial Cables to the Upstream Channel Ports
To connect cables to the upstream channel ports follow these steps and refer to
0
1
2
3
4
5
To T1/E1-based
BITS source
bsr2k030
BITS
RED