Release 1.0
Configuring PacketCable
526360-001-00 Rev. B
MGBI
7-25
Deleting Security Policy Database Policy Entries
Follow these steps to delete Security Policy Database (SPD) policy entries:
1.
Issue the
no spd policy
command in IPSec Configuration mode to delete SPD
entries when they are no longer needed. A single rule or all the rules in the table
can be deleted at once:
MOT(config-ipsec)#
no spd policy
{
all
| <
num
>}
where:
all
deletes all entries in the SPD.
num
deletes a specific rule from the SPD specified by the index number.
2.
Issue the
show ipsec spd policy
command to verify if the appropriate SPD policy
was deleted.
Displaying the IPSec Configuration
Use the following commands in all modes except User EXEC mode to display the
IPSec configuration.
■
Issue the
show ipsec ike
command to display the IKE configuration.
Note:
Use caution when deleting more than one SPD entry, because the
SPD index numbers change whenever an index is deleted.
Summary of Contents for BSR 2000
