Motorola BSR 2000, Configuration And Management Manual

Page: 40 / 650

BSR 2000 Configuration and Management Guide Release 1.0
2-8 MGBI 526360-001-00 Rev. B
To exit Route-map Configuration mode and return to Global Configuration mode,
enter the
exit or end commands. To exit Route-map Configuration mode and return to
Privileged EXEC mode, press Ctrl-Z .
Cable Spectrum Group Mode
The spectrum management system monitors the upstream signal integrity, and collects
upstream spectrum information. Cable Spectrum Group mode is used to configure a
spectrum group, apply a spectrum group to an upstream port, and evaluate spectrum
performance. The following command example shows how to enter Cable Spectrum
Group mode from Global Configuration mode:
MOT (config)#
cable spectrum-group <
WORD
>
MOT
(config-spcgrp:<
WORD
>)#
(
WORD
= the name of the which will also be reflected in the prompt, i.e.
MOT
(config-spcgrp
:newgroup
)
To exit Cable Spectrum Group mode and return to Global Configuration mode, enter
the
exit or end commands. To exit Cable Spectrum Group mode and return to
Privileged EXEC mode, press Ctrl-Z .
Command Mode Summary
Table 2-2 provides details on entering each command mode, the prompt display,
navigating through the command mode hierarchy, and exiting each command mode.