Motorola BSR 2000, Configuration And Management Manual

Page: 113 / 650

Release 1.0 Configuring the System
526360-001-00 Rev. B MGBI 3-63
3. Enter the full path from the FTP root directory and the new application or boot
image file name after the
Source file name prompt and press the Enter key.
Source file name [ ]?
For example:
Source file name [ ]? /pub/image_file.Z
4. The Destination file name prompt displays with the new file name. Press the
Enter key to accept the new file name in NVRAM. For example:
Destination file name [ image_file.Z ]?
The file is successfully copied to NVRAM.
5. Compare each image file size (in bytes) in NVRAM to the original size of each
image file size on the server. To view the new image files in NVRAM, use the
dir
command in Privileged EXEC mode as shown below:
MOT#
dir
The following command output displays:
6. If the image file byte counts in NVRAM match the image file byte counts on the
server, the image files have been copied successfully.
Downloading Image Files to Flash Memory
Both boot and application image files can be downloaded to flash memory using the
FTP or TFTP file transfer process.
Note: You can optionally rename the image file name stored in NVRAM. If
you decide to enter a new file name in NVRAM, enter the new file name after
the
Destination file name prompt. For example:
Destination file name [ image_file.Z ] ? <new file name>