Installing the MoCA Adapters
SBM1000 SMART Video Adapter Kit
•
User Guide
25
590631-001-a
4.
Connect one of the Ethernet cables (included) to one of the
Ethernet
ports on the SBM1400
and the
Ethernet/network
port on your Smart TV or other Smart device (see Figure 21).
Repeat for each additional SBM1400 Ethernet connection with other networked audio-visual
devices, if applicable.
5.
Connect one of the power adapters (included) to the
Power
port on the SBM1400 and plug it
into the electrical wall outlet.
Figure 21 – Room 1: SBM1400 Adapter Installation
To install the SBM1100 (see Room 2 in Figure 20):
6.
Connect the coaxial cable (included) to the
Coax In
connector on the SBM1100 and the
RF
port on the cable wall outlet.
7.
Connect one of the Ethernet cables (included) to one of the LAN Ethernet ports on your
residential modem/gateway and the Ethernet port on the SBM1100.
8.
Connect one of the power adapters (included) to the
Power
port on the SBM1100 and plug it
into an electrical wall outlet.
ο
The
Coax
LEDs on both MoCA adapters should turn ON within five minutes to indicate
that a secure coaxial connection was established between the two adapters.
ο
If the
Coax
LED does not turn ON within five minutes, disconnect and then reconnect
the power adapters on the SBM1100 and SBM1400. If the Coax LEDs still fail to turn
ON, see
9.
Power ON your Smart TV, set-top box, laptop, and any other Ethernet-connected devices.
You can now configure your Smart TV and other Ethernet-enabled devices for Internet access
through their related user interfaces.
See