5 - 4
Workabout Pro4 (Windows Embedded Hand-Held 6.5) User Manual
Power Consumption Considerations
Check to ensure the mains circuit supplying chargers and/or docking stations is adequate for the load, espe-
cially if several chargers and docking stations are being powered from the same circuit.
Operator Controls
Workabout Pro4 docking stations and chargers have no operator controls or power switches.
Important Charger Safety Instructions
•
SAVE THESE INSTRUCTIONS
– This manual contains important safety and operating instructions for
battery chargers.
•
Before using the battery charger, read all instructions and cautionary markings on (1) battery charger, (2)
battery, and (3) product using battery.
•
The mains power cord shall comply with national safety regulations of the country where the equipment is
to be sold.
•
Use of an attachment not recommended or sold by the battery charger manufacturer may result in fire,
electric shock, or personal injury.
•
To reduce risk of damage to the electric plug and cord when unplugging the charger, pull the plug rather
than the cord.
•
Make sure the cord is positioned so that it is not stepped on, tripped over, or otherwise subjected to
damage or stress.
•
Do not operate the charger with a damaged cord or plug. Replace immediately.
•
Do not operate the charger if it has received a sharp blow, been dropped, or otherwise damaged in any
way; it should be inspected by qualified service personnel.
•
Do not disassemble the charger; it should be repaired by qualified service personnel. Incorrect reassembly
may result in electric shock or fire.
•
To reduce risk of electric shock, unplug the charger from the outlet before attempting any maintenance
or cleaning.
•
An extension cord should not be used unless absolutely necessary. Use of an improper extension cord
could result in fire or electric shock. If an extension cord must be used, make sure:
The plug pins on the extension cord are the same number, size and shape as those on the charger.
The extension cord is properly wired and in good electrical condition and that the wire size is larger than
16 AWG.
•
Do not expose the charger to rain or snow.
•
Do not place batteries in the charger if they are cold from extended exposure to a freezer or outside tem-
peratures below 10°C (50°F). Allow them to warm up to room temperature for at least two hours.
•
Do not use the charger if, after an overnight charge, any of the batteries feel warmer than the charger
housing. The charger should be inspected by qualified service personnel.
•
Do not use the charger if any of the batteries or the charger get more than lukewarm. The equipment
should be inspected by qualified personnel.
Desktop Docking Station
The Workabout Pro4 can be inserted in a desktop docking station, model number WA4003-G2.
Draft #6
Summary of Contents for 7528X
