Motorola solutions Mag One VZ Series, Service Manual

Page: 1 / 48

Mag One
Motorola Solutions, Inc.
VZ Series
Service Manual
©
2017 Motorola Solutions,lnc.
跚跚跚跚跚跚nu
｜
川川川
2
MMMMMEU
｜
川MMM川
nu
｜
回回回回回nu
｜
mmmmmmnu HHHHHHMm HHHHHue－M MMMZ
刷刷刷刷刷刷户U
In tro,l u ction
This manual provides technical in formation necessary for servicing the VZ series FM Transceiver.
Servicing this equipment requires expertise in handling surface-mount chip components. Attempts by non-qualified
per-sons to ser可ice this equipment may result in permanent damage not covered by the wa
付
anty, and may be illegal
mso
口1
e countnes.
One PCB l ayout diagrams are provided for each double-sided circuit board in the transceiver. Each side of is referred
to by the type of the majority of components installed on that side （
“
leaded
”
or气hip-only勺. In most cases one side
has only chip components, and the other has either a mixture of both chip and leaded components (varister, coils,
electrolytic capacitors, ICs, etc.), or leaded components only.
While we believe the technica l information in this manual to be correct, Mag One assumes no liability
for damage that may occur as a result of typographical or other errors that may be present. Your cooperation in pointing
out any inconsistencies in the technical information would be appreciated.
/
Important Note
This transceiver was assembled using Pb (lead) free solder, based on the Ro HS specification.
Only lead-free solder (Alloy Composition: Sn-3.0Ag-0.5Cu) should be used for repairs performed on this apparatus.
The solderstated above utilizes the alloy composition required for compliance with the lead
』
freespecification, and
any solder with the above alloy composition may be used.