Figure 5: Securing Ball Portion
2.3
Securing the Ball Joint Mount
Procedure:
1
Tighten the outer nut with the 0.5 in. Wrench .
2
Use the 0.5 in. Socket Wrench to hold the inner nut in place.
3
Check the threads of the bolt, to ensure that they do not extend past the edge of the nut on the
inside of the Security Enclosure, as shown in the following image.
NOTICE:
The camera will not fit inside the enclosure if the bolt threads protrude past the
locking nut.
Figure 6: Securing the Ball Joint Mount
MN007598A01-AD
Chapter 2 : Getting Started
12
