Installation Instructions: Honda 10-401-SS
EPCO Products, Inc.
Fort Wayne, IN USA
1-844-MotorM8 (668-6768)
epcomarineproducts.com
The cover around the contact points could be damaged and/or cracked if instructions are not followed.
MotorMate is not responsible for any damage to the MotorMate unit or any part of the motor due to improper installation or use.
Package Contents:
1
4
5
2
3
RV:3062015
MADE IN THE USA
Call 1-844-MotorM8 (668-6768) for assistance with installation
(3.25")
(7.19")
Reference Images:
(7.19")
(3.25")
A
B
MotorMate Locking Pin.
Confirm Measurements Prior to Installation
It is necessary to confirm the spacing of the contact points on the
outboard motor are the same as A.
The motor yoke spacing A is the Center to Center distance
between the motor contact points securing the MotorMate to the
motor drive shaft housing. See Reference Image A below.
The transom mount spacing B is measured between the inside
edges of the stern brackets. See Reference Image B below.
Raise motor and straighten
before engaging the MotorMate.
Clip Locking Pins into holes in
transom stern brackets.
Lower motor very slowly and stop one inch
away to make sure the MotorMate End Caps
are aligned with the contact points on the
motor.
Example of the recessed areas containing
the contact points where the MotorMate
End Caps secure the motor and where the
outboard motor center to center
measurements are made.
Continue lowering the motor while
aligning the MotorMate End Caps with the
contact points until the motor is securely
held in place.
Honda Installation Video: motormateusa.com
Measure between
center to center
distance between
the contact points.
Measure between
the inside edges of
the stern brackets.
