Motorhispania MH7 Naked, Workshop Manual

Page: 27 / 138

34
N.B.
PAY MAXIMUM ATTENTION TO THE POSITION OF
THE SEPARATING BUSHES. DO NOT APPLY THE
BRAKE PEDAL DURING THIS OPERATION IF YOU DO
SO, YOU WILL NEED TO DRAIN THE BRAKE FLUID
AND OPEN THE PAD TO REINSERT THE BRAKE DISK
WHEN REFITTING THE WHEEL.
FRONT WHEEL
REMOVAL
Remove the front mudguards (see section).
Remove the (A) left-hand side wheel shaft nut (B)
Remove the mileometer take-off (C).
Loosen the bolt (D) on the right-hand fork arm securing
the shaft (B).
Extract the wheel (B) until the separator (E), the wheel
and the separator (F) are freed.
D
F
B
A
C
E
WARNING
-PLACE THE MACHINE ON A FLAT SURFACE.
-STAND THE MACHINE ON A SUITABLE SUPPORT, IN
SUCH A WAY THAT THE FRONT WHEEL IS OFF THE
GROUND.
ASSEMBLY
• Insert the shaft (B) into the right-hand fork arm.
• Insert the separator (F) on the shaft.
• Fit the wheel and insert the shaft (B).
• Insert the separator (E).
• Insert the shaft (B) into the left-hand fork arm.
• Fit the mileometer take-off (C).
• Fit the nut (A) and tighten it.
• Fit the shaft with the bolt (D).
• Fit the front mudguards
(see section).
•
•
•
•
•
4 CHASSIS
Set spanner
Allen key