Motor Power Company DUET_FL 48/10, User Manual

Page: 169 / 196

Page 169
Connectors at the DUET_FL 48/10
Connection: Power supply and I/O [X1]
 Configuration on the device: AMP Junior Timer 1-963215-1
 Mating connector [X1]: AMP 1-963217-1 / contacts: 929938-1
8 7 6 5 4 3 2 1
15
16
12 1413
11 10 9
Figure 33: Numbered pins of X1 DUET_FL 48/10
Table 27: Pin assignment of connector [X1]
Pin no. Name Value Specification
1
DIN9 0 V...24 V Digital input: Power stage activation
2
DIN7
0 V...24 V
Digital input: Limit switch 0 (blocks n > 0)
3
CANHI
(DIN4)
0 V...24 V
CAN high
(Digital input: Positioning group selector bit 0)
4
AIN1
(DIN2)
((DOUT1)) -10 V...10 V
(0 V...24 V)
((0 V...24 V))
Analog input 1: Differential analog input with #AIN1
(Digital input: Positioning destination selector bit 2)
((Digital output: Freely programmable / encoder output track
A))
5
AIN0
(DIN0)
-10 V...10 V
Analog input 0: Differential analog input with #AIN0
(Digital input: Positioning destination selector bit 0)
6
RxD +/-10 V Reception signal, RS232 specification
7
GND 0 V
Shared ground potential for the DC bus voltage and the
24V logic supply.
8
ZK+ +48 V / 15 A
nom.
Intermediate circuit supply (DC bus)
9
DOUT0 /
READY
0 V / 24 V Ready for operation
10
DIN8 0 V...24 V Digital input: Limit switch 1 (blocks n < 0)
11
CANLO
(DIN5)
0 V...24 V
CAN low
(Digital input: Positioning group selector bit 1)
12
#AIN1
(DIN3)
((DOUT2)) -10 V...10 V
(0 V...24 V)
((0 V...24 V))
Negative analog input 1: Differential analog input with AIN1
(Digital input: Positioning destination selector bit 3)
((Digital output: Freely programmable / encoder output track
B))
13
#AIN0
(DIN1)
-10 V...10 V
Negative analog input 0: Differential analog input with AIN0
(Digital input: Positioning destination selector bit 1)
14
TxD +/-10 V Transmission signal, RS232 specification
15
AMON0
(DIN6) 0 V...10 V; 2 mA
(0 V...24 V) Analog monitor 0
(Digital input: Positioning start)
16
+24V Logik
+24 V / I
Logik
=
200 mA...1000 mA
24 V power supply for the internal logic and the IOs. Shared
ground with the intermediate circuit (DC bus)
User Manual DUET_FL „DUET_FL 48/10“ Version 1.1 Motor Power Company