3-1
HW0482170
HW0482170
3
Installation
• Install the safeguarding.
Failure to observe this warning may result in injury or damage.
• Install the manipulator in a location where the manipulator’s tool or the
workpiece held by the manipulator will not reach the wall, safeguarding,
or NX100 when the arm is fully extended.
Failure to observe this warning may result in injury or damage.
• Do not start the manipulator or even turn ON the power before it is
firmly anchored.
The manipulator may overturn and cause injury or damage.
• When mounting the manipulator on the ceiling or wall, the base section
must have sufficient strength and rigidity to support the mass of the
manipulator. Also, it is necessary to consider countermeasures to pre-
vent the manipulator from falling.
Failure to observe these warning may result in injury or damage.
• Do not install or operate the manipulator that is damaged or lacks parts.
Failure to observe this caution may cause injury or damage.
• Before turning ON the power, check to be sure that the shipping bolts
and brackets explained in " 2.2 Shipping Bolts and Brackets " are
removed.
Failure to observe this caution may result in damage to the driving parts.
WARNING
CAUTION