Australian owned
Australian designed
61 (0)3 9876 0400
[email protected]
www.motolux.com.au
Ordering Information
Australia / New Zealand
1 CHANNEL MOTOR CONTROLLER WITH BUILT IN RADIO RECIEVER – 807110000
Pairing A Multi-Channel Remote or Multiple Remotes
PROGRAMMING INSTRUCTIONS 1/3
*Please note that a maximum of 5 Remotes/Channels or Devices can only be paired to each single channel Motor Control Unit
Pairing the Motor controller to a Remote Control:
1. Make sure power is switched on to the motor controller.
2. Press and hold the ‘Learn’ button on top of the motor control box for 1 second, you will be able to see a slow flashing
RED
light behind the tinted screen.
3. Now on the remote control, making sure you are on the right channel/remote, briefly press the
up
button. The motor
controller will emit three
BLUE
flashing lights to indicate that the channel/remote is paired.
To Change Direction of the Motor (Two Methods)
(First method):
1. On a channel that is paired to the remote, push and hold the Stop Button for three seconds. the
RED
light on controller will
start flashing at a slow steady rate.
2. Now push the Down Button and the and the light inside the controller will flash
BLUE
three times to confirm that the
direction is changed.
3. Test the motor.
(Second method):
1. Undo the screw at the bottom of the motor controller and slide the front cover off.
2. Towards the top of the circuit board, you will be able to see a dip switch. Flick the switch to either left or right to change the
motor direction.
3. Test the motor.
To Take the Motor Out of Venetian Blind Mode:
In case the Motor Controller is set to Venetian Blind Mode you will need to:
1. On a channel that is paired to the remote, push and hold the Stop Button for three seconds. the
RED
light on the controller
will start flashing at a slow steady rate.
2. Now briefly push the Stop Button and the and the light inside the controller will flash
BLUE
three times to confirm that the
motor has been taken out of venetian mode.
3. Test the motor.
To Delete a Single Channel or a Remote from the Motor Controller:
If by chance a remote or channel has been paired by mistake, follow these steps to remove it:
1. On the Motor Controller, push and hold the stop button on the remote. The
RED
light on controller will start flashing at a
slow steady rate.
2. Making sure that you have the remote on the correct channel to be deleted, push and hold setting button on the remote until you
see the
BLUE
light in the Motor Controller flash three times confirming that you have deleted that channel or remote.
3. Test the motor.
Motolux is a world-class manufacturer of motorisation products and systems dedicated to window covering markets
worldwide. A designer and manufacturer of a fully integrated range of motorisation solutions, Motolux products are
suitable for commercial or residential use. Our high quality product range is streamlined to simplify the process of
manufacturing, installation and ongoing maintenance of almost any type of motorised window covering product.
REVISION 1 - 2021