Australian owned
Australian designed
Motolux is a world-class manufacturer of motorisation products and systems dedicated to window covering markets
worldwide. A designer and manufacturer of a fully integrated range of motorisation solutions, Motolux products are
suitable for commercial or residential use. Our high quality product range is streamlined to simplify the process of
manufacturing, installation and ongoing maintenance of almost any type of motorised window covering product.
61 (0)3 9876 0400
[email protected]
www.motolux.com.au
Ordering Information
Australia / New Zealand
Pairing the Sensor to a Motolux RF Motor
Setting Up the Sun/Wind Sensor for Operation
PROGRAMMING INSTRUCTIONS 1/2
1.
On the Remote, Push and Hold the STOP button until the motor gives a jiggle.
2.
Within 10 seconds, Push and Hold the “Learn” Button on the underside of the
Sensor; the motor will give a jiggle indicating that paring was successful.
• This model does not have a Rain Sensor function but retains this button for programming purposes.
• Zero in any function will indicate that function will be switched off, e.g. Wind Sensor setting 0 will switch off the Wind
Sensor function.
• Each button will increase the increment values from 0 - 9 and will return to 0 once past 9.
• Looking at the screen from left to right
Please note that Blinds and Awnings should be Paired, and Limits set with a
Remote Control first before pairing the Sun/Wind Sensor.
The Left-hand digit indicates the Wind setting with a range of 0 – 9, a setting of 0 turns off the function.
The Left-Hand Button looking at the screen controls the Wind Sensor setting function, push this button repeatedly until
the desired level is reached.
The middle digit indicates the Light setting with a range of 0 – 9, a setting of 0 turns off the function.
The Middle Button looking at the screen controls the Light Sensor setting function, push this button repeatedly until the
desired level is reached.
Reaction time is 3 seconds once the set threshold is reached, the sensor will then retract the Blind or Awning.
For safety, the Blind or Awning cannot be operated by Remote Control for 5 minutes after the wind speed falls below the
set threshold.
When pre-set Light levels have been reached for 1.5 minutes of constant light, the sensor will then extend the Blind or Awning.
Once the Light Level has dropped below the pre-set value for 1 minute consistently, the sensor will then withdraw the Blind
or Awning.
*For the Light Sensor to be effective the top of the unit must have a clear view of the sky, please do not install the unit under eves or
where it will be affected by trees or branches casting shadows onto the sensor.
The below table shows each Wind Speed setting range.
The below table shows each Light Intensity setting range.
Please Note:
Wind Sensor
Light Sensor
REVISION 2 - 2021
Motolux Solar Powered Sun and Wind Sensor - 801811001
Setting values
Light setting button
Rain button
Learn button
Wind setting button
Wind Speed
10Km/h
15Km/h
20Km/h
25Km/h
30Km/h
35Km/h
40Km/h
45Km/h
50Km/h
Wind Force
Level 1
Level 2
Level 3
Level 4
Level 5
Level 6
Level 7
Level 8
Level 9
Light Intensity
0.2 Klux
........................................................................................................................................
10Klux
Setting
1
2
3
4
5
6
7
8
9