Motion CM-07, Manual

Page: 18 / 124

14.2
14.1
13.1
13.2
13.3
13.4
13
14
MOTION
C M - 0 7 D C M I D M O T O R
Move the blind to a desired favourite position.
Press the program button on the motor to activate
program mode. The blind starts stepping.
Hold the centre button to save this favourite position. The blind shortly stops
stepping, indicating the favourite position has been saved succesfully.
Press the program button on the motor to deactivate
program mode. The blind stops stepping.
Press the program button on the motor to activate
program mode. The blind starts stepping.
Hold the program button until the blind stops stepping (approximately 5 seconds)
to deactivate or reactivate direct control.
When pressing the up or down button on the remote control, the blind directly moves to
its end positions (direct control). To operate the blind with smaller steps using the up and
down button, direct control can be deactivated. Now, the blind only directly moves to its end
positions when the up or down button is held longer than two seconds.
Centre
Reset favourite position
Deactivate direct control (Recommended for Venetian blinds)