Mothers choice journey, Instruction Manual, Page: 31 / 36

• vvv
31
Vehicle metal
structure
Spacer(s)
(if required)
Attachment bolt
Anchor fitting
Vehicle trim
Vehicle metal
structure
Spacer(s)
(if required)
Attachment bolt
Anchor fitting
Vehicle trim
Lock washer
Nut
Reinforcing
washer
Centre line of
seating position
200mm
min.
FOR SEDANS ONLY:
Front of vehicle
journey
upper anchorage fitting installation
FOR CARS FITTED WITH A CHILD RESTRAINT
UPPER ANCHORAGE POINT
Locate the upper anchorage point behind the rear
seating position (consult the car owner’s handbook
for the location of the upper anchorage point).
Remove the thread plug from the parcel shelf/floor/
roof and install the attachment bolt as shown in
Figure 3.
CAUTION: DO NOT OVERTIGHTEN THE ATTACH-
MENT BOLT. OVERTIGHTENING MAY FRACTURE
OR BREAK BOLT. MAXIMUM TORQUE IS 20 Nm.
FOR CARS NOT FITTED WITH A CHILD
RESTRAINT UPPER ANCHORAGE POINT
For sedans only
Drill a 9mm diameter hole in the parcel shelf on
the centre-line of the seating position as shown
in
Figure 3a. Install the anchor bolt as shown in
Figure 3b. It is recommended that this installation
be carried out by a child restraint fitting station or
licenced motor mechanic.
For vehicles other than sedans
In Australia, consult your nearest child restraint
fitting station or traffic authority for vehicle
inspection to find the best, correct position for
the placement of the upper anchorage point, and
for the correct attachment bolt length and use of
spacers. In New Zealand, consult the agent for the
vehicle.
3
3a
3b