User Guide
Industrial Actuator
Model: ID10
MOTORIZE OUR WORLD
R
CAUTION
CAUTION
The load should be centered on the operating direction.
KG
Load
Side load is NOT good for actuators.
KG
Side Load
MANUAL DRIVE (MD) CONNECTOR
The MD (manual drive) is an alternative way to drive the motor directly, if the power is not available.
Step 1.
Remove the plug on the gearbox cover.
Step 2.
Use a 8.0mm hex bit or electric screwdriver (recommended) to drive the gear directly.
Step 3.
Insert the plug into the hole, and confirm the plug is installed properly.
Gear
Plug
●
The Max. drive torque is 6kg-cm with 4500N load.(Ball Screw)
For ID10 actuators, connection rule of power wires varies according to different types and gear ratio(s).
Please follow the instructions below.
WIRE CONNECTION
Standard Type
●
Please refer to the table below to define the actuator's extension. When Red (M+)
is connected to "+" and Black (M-) is connected to "-" of DC power, the actuator
will extend.
M+
M-
Red
Black
Gear ratio
Power
M-
30:1,
40:1
M+
5:1,
10:1, 20:1