21
LEGS TO BASE: FOR STEPS 6-7
(2)
3/8”
x 2 Hex Head Bolts
(2)
3/8”
Washers
(2)
3/8”
Nyloc Nuts
FEET TO LEGS: FOR STEPS 8-10
(2) ¼”-20 x 2 1/2
Panhead Screws
(2) ¼” -20 Nyloc Nuts
(2) ¼
”
Washers
UPPER LEGS TO LOWER LEGS: FOR STEPS 12-13
(2) ¼”-20 x 1 3/4 Panhead Screws
(2) ¼” -20 Nyloc Nuts
(2) ¼
”
Washers
ASSEMBLY INSTRUCTIONS
Trap Assembly:
Step 1
Place base upside down on a flat surface, unfold U-shaped support leg until it locks in
place.
Step 2
Turn base and leg assembly right-side-up and place support pole into cavity on base.
Step 3
Place Mosquito Magnet® Liberty Plus power head onto pole. Press down firmly with
two hands to secure. Assembled trap should have the front of power head in the same
direction as base U-shaped legs.
Step 4
See Mosquito Magnet® Octenol Mosquito Attractant Package for details. Insert the
Plume Tube into horn and turn until Tube locks into place.
Step 5
Charge Mosquito Magnet
®
Liberty Plus for 24 hours before use. See below for
further details.
NOTE:
You will not need to charge it again until the following season.
If your trap remains off for an extended period of time, you may need to recharge the
battery.
