Morris CX 8105, Operator'S Manual, Page: 173 / 182

Troubleshooting
Problem Cause
Correction
CX 8105 - Ground Drive December 2016 9-5
Air delivery hoses loose, cracked
or pulled off.
Inlet screen to fan blocked off.
Incorrect Seed Plate installed.
Seed Plate lock not adjusted
correctly.
Material caked up above one or
more of the metering cups.
Excessively damp material in
tank.
Foreign obstruction in tank above
metering wheels.
Caked up metering wheels on
some or all of the metering cups.
Damaged metering wheels.
Metering wheels mismatched to
secondary outlet.
Collector Valves set incorrectly
on Double Shoot machines.
Air Leak in System.
Meterbody pressurization hose
disconnected.
Tighten the hoses, replace cracked hoses or install
hoses pulled off their respective locations.
Clean off material that is blocking the fan screen.
Install correct Seed Plate
Adjust Seed Plate lock - See Maintenance Section.
Clean out caked up material.
Use reasonably dry, fresh material only.
Remove obstruction, and always fill tanks through
the screen.
Clean out the metering cups and wheels.
Replace broken metering wheels.
Install correct wheels to head.
1 3/4” wide wheel for 7 outlet head.
2” wide wheel for 8 outlet head.
2 1/4” wide wheel for 9 outlet head.
2 1/2” wide wheel for 10 outlet head.
Be sure appropriate spacers are also used.
See Operation Section.
Adjust lids and doors as necessary.
Replace damaged seals.
See Maintenance Section.
Reconnect hose to meterbody/plenum.
Material not being accurately
metered out of the metering
body
Air Delivery - Continued