Morris CX 8105, Operator'S Manual, Page: 109 / 182

Monitor
CX 8105 - Ground Drive December 2016 6-23
Blockage Sensing - Continued
Blockage Module Test
This test will check the blockage module for proper
functioning. Number of runs reported should match the
number of sensors connected to each module.
To perform the blockage module test follow the steps
below.
1. Stop driving the machine.
From the “Operating Screen” press the MENU key
to enter the “Settings Menu”.
Use the Up/Down keys to highlight “Blockage Module
Settings” press the SELECT key to enter the function.
Use the Up/Down keys to highlight “Blockage Module
Test” press the SELECT key to enter the function.
2. The monitor will indicate when a module test is
complete. Testing may take a few minutes depending
on configuration and application.
3. Once all modules have completed their test the
monitor will display how many optical sensors each
module could communicate with. If this number does
not match the actual number connected check the
wiring and installation of the sensors.
4. Once all of the modules have been tested use the
Up/Down keys to highlight “Exit” press the SELECT
key to return to the “Blockage Module Settings” menu.
Use the Up/Down keys to highlight “Exit and Save”
press the SELECT key to save the changes and
return to the “Settings Menu”.
At any time during this test, CANCEL may be pressed
to exit the “Blockage Module Test”.
1
2
3
4